|
Wireless Motion Detector, Home Security Alarm
Wireless Motion Detector, Home Security Alarm with Key Chain Remote
The wireless motion detector can be used as a portable alarm or can be wall mounted where the adjustable PIR (passive infrared) sensor will detect movement over an area of 30 feet by 110 degrees. It can be alarmed/disarmed with the enclosed infrared remote control unit. The chime feature can be used to announce visitors at the home or office.
OPERATION
Remove the back of the unit by unscrewing the screw located at the top of the locked battery compartment and slide down. Insert three AA alkaline batteries (not included) into the compartment located in the back of the unit. Alternatively, a 7.5-15 volt adapter (not included) can be connected to the jack socket located at the side of the unit. The unit is also equipped with terminals for use with the magnetic contacts.
Batteries are included in your remote control. When batteries run low, replace them with two 1.5 volt type button cell batteries. Simply open remote control by removing screws and replace batteries.
Enclosed you will find:
• Wireless motion detector
• Mounting bracket
• Magnetic contacts
• Remote control
• Two 1.5 volt batteries (installed)
• Wall anchors
• Screws
Tools and Supplies Needed:
• Small flat headed screwdriver
• Small Phillips head screwdriver
• Ballpoint pen
• 7/32” drill bit
Batteries Needed (not included):
-Three alkaline “AA” batteries
In Stock
|
